Used to accurately test flexible springs with a high length to diameter ratio. The three support columns locate on either the I/D (inner diameter) or O/D (outer diameter) of the spring. This prevents concave or convex movement thereby maintaining accuracy of results. Supplied complete with dedicated 50mm compression plate (nickel plated).

This fixture must be used with the long extension 49755-0921 and cannot be used on MDD/P or LCP test stands due to reduced height.

The carriage of the peel table is directly driven by the movement of the test stand crosshead so maintaining an accurate 90° peel throughout the test cycle and removing any friction effect on the resultant force reading.

Also required:

Grips for holding sample to mounting plate of peel table - see grips for holding lids/materials.

Designed for use with TC² motorized test stand.

Optional smooth or serrated cams allow quick and positive clamping for cables up to to 6mm diameter. For tests to BSI spec. BS5G178 PART 1 and equivalent international standards. Supplied with 10/32 screw for mounting on the base plate of the stand.

Special quick acting double cam grip for rapid repeat testing of substrates for tests to BSI spec. BS5G178 PART 1 and equivalent international standards. Supplied with 10/32 screw for mounting on the base plate of the stand.

Adjustable to suit a wide range of flag terminals.

Crimp termination holder for tests to BSI spec. BS5G178 PART 1 and equivalent international standards. Adjustable for 10 sizes from 1.5mm (0.6") to 5mm (0.2").

Accessory for insertion and withdrawal testing to BS 5057 and equivalent international standards. Available with master spades or spade terminal holder. Supplied with 10/32 screw for mounting on the base plate of the stand.